lm3系列擺線液壓馬達
主要性能參數 main specification
1.最大工作壓力指入口最大壓力,額定壓力指工作壓差。
2.馬達不能同時在最大壓力和最高轉速下工作。
3.在斷續工作條件下,運行時間每分鐘不得超過10%。
4.推薦用68#抗磨液壓油,粘度37-73cst,清潔度iso18/13。
5.最高工作油溫80°。
6.馬達全負荷工作前,應在最高工作壓力的40%以下磨合1小時。
7.馬達允許最高背壓10mpa,但建議不要超過5mpa,超過 時應接外泄油管.
1. intermittent means the entrance of the maximum pressure; continuous working pressure means the differential pressure
2. motor should not work under the highest pressure【敏感詞】the maximum speed
3. the running time should not exceed 10% under intermittent working conditions
4. recommending n68 anti-wear hydraulic oil, viscosity 37-73cst, cleanliness iso18/13.
5. the maximum working temperature is 80 °
6. one hour running time under 40% of maximum working pressure is recommended before full capacity working.
7. the maximum allowable back pressure is 10mpa, but the recommended back pressure should not exceed 5mpa.a leaking pipes isneeded when exceeding
lm3 連接尺寸----外形圖 dimension【敏感詞】mounting data
lm3訂貨信息 ordering information
lm3 ordering information